User`s manual

83
4 User's Reference
Verify the response from the print server (Roland-PrintServer).
For more information about how to verify this, see below.
For Windows
"4-6 Network Connection Setup 5) Check the response from the print server."
For Macintosh
In the included "Roland-PrintServer for Macintosh Users," follow the instructions in "Setting the IP Address for the Print Server and
Verifying the Network Connection."
When there is a response from the print server
The network connection is correct. Check the following.
- The Roland COLORCHOICE
®
setting for the output destination
When there is no response from the print server
Check for a response from another computer connected to the network.
If checking from the other computer shows a response from the print server, check the computer that did not receive a response.
One of the following may be the cause.
Investigate and eliminate the cause, so that the correct response is obtained.
- The network cables are not connected correctly.
- The computer's TCP/IP setting is incorrect. (When checking the TCP/IP settings, refer to "Verifying the Computer's TCP/IP Settings.")
There is no response from the print server at any computer
One of the following may be the cause.
Investigate and eliminate the cause, so that the correct response is obtained.
- The FJ-500/400 is not turned on.
- The network device is not turned on.
- The power cord is not connected correctly.
- The network cables are not connected correctly.
- The network cable is suffering from a broken wire or faulty contact.
If the network cable is suffering from a broken wire or faulty contact, replace it with a new network cable. If you are using a 100Base
TX Ethernet network, use Category 5 cable.
- The computer's TCP/IP setting is incorrect. (When checking the TCP/IP settings, refer to "Verifying the Computer's TCP/IP Settings.")