User`s manual

74
4 User's Reference
Default
value
Setting
range
FunctionSubmenu
Top
menu
SLEEP This sets the time that elapses before the unit enters the SLEEP mode.
The SLEEP mode is enabled when the FJ-500/400 has been inactive
for a specified time. (When in the SLEEP mode, the POWER LED
flashes once per second.)
To release the SLEEP mode...
- Touch any key on the control panel.
- Send data from the computer (only when the SETUP LED is lit).
- Open the front cover.
- Move the sheet loading lever toward the back of the unit.
— NONE/15
min to
120 min
(In steps of
15 min)
— mm/INCH mmThis selects millimeters or inches as the unit of measurement for the
width displayed on the top menu after setting up the material. When
inch display is used, values are displayed to the first digit to the right of
the decimal point.
UNIT
— OR-GR/
Lc-Lm
OR-GRMake this setting when you are using data for six-color printing.
It has no effect on processing data for four-color or eight-color
printing.
The menu is for performing printing using six-color printing data for
older Hi-Fi JET models from Roland DG Corp.
When processing six-color printing data as KCMY + OrGr (black,
cyan, magenta, and yellow plus orange and green, choose [OR-GR].
When processing the six-color printing data as KCMY + LcLm (black,
cyan, magenta, and yellow plus light cyan and light magenta), choose
[Lc-Lm].
* Performing printing using six-color data for an older model requires
taking into account the differences in resolution and the amount of
ink received, and adjusting the output profile appropriately. Note that
the output results will not be exactly equivalent to those obtained
with the older model.
Also, if the FJ-500/400 is set to a printing mode that is not
compatible with the older model, correct output results may not be
obtained even when six-color printing data is sent.
The only printing mode on the FJ-500/400 that is compatible with
older models is NORMAL.
[OR-GR]: In the six-color data, the two colors other than KCMY
(black, cyan, magenta, and yellow) are processed as OrGr (orange and
green).
[Lc-Lm]: In the six-color data, the two colors other than KCMY
(black, cyan, magenta, and yellow) are processed as LcLm (light cyan
and light magenta).
6COLOR
MODE
15 min
SYSTEM
REPORT
— ——This prints the current status of settings and other system information.
— ——This returns all menu settings to their original values when shipped
from the factory.
For more about the factory defaults for the various settings, see the
"Default value" entry for each menu setting in this section.
FACTORY
DEFAULT
— ——INK
REMAINING
This shows the amount of ink left after each of the ink cartridges has
been installed.
The fewer the markers ("
"), the less ink is left.
* If a partially used ink cartridge is removed and reinstalled, or if a
partially used ink cartridge is installed, the cartridge is taken to be
unused, and the displayed amount of remaining ink is not true.
For more information, see "3-2 Checking the Remaining Ink Level."