User`s manual

61
3 Maintenance
3-8 When Moving the Unit...
When moving the unit, first carry out head washing, then secure the carriage in place. Head washing requires
four optionally available cleaning cartridges.
NOTICE
If there is material loaded, hold down the [SETUP] key
for 1 second or longer to cancel setup, then remove the
material (see "2-6 Ending Printing Operations Remove
the Material").
1
SET CLEANING
LIQUID[OGcmKCMY]
Insert a cleaning cartridge into the ink cartridge port
for the flashing color.
REMOVE CLEANING
LIQUID[OGcmKCMY]
Remove the cleaning cartridge from the ink cartridge
port for the flashing color.
Messages appearing during head washing
O = Orange, G = Green, c = Light Cyan, m = Light Magenta,
K = Black, C = Cyan, M = Magenta, Y = Yellow
Continued on the next page
After you have pulled out all the ink cartridges whose
colors are flashing, head cleaning starts. Follow the
messages on the display to carry out the procedure.
When cleaning for the first four colors finishes, the
display returns to the screen shown in step 6. Follow
the messages on the display to perform cleaning for
the remaining four colors.
7
Mount the drain bottle and press the [ENTER] key to
display the screen shown in the figure.
6
REMOVE CARTRIDGE
[OGcmKCMY]
When the display shown in the figure appears, discard
the discharged ink in the drain bottle.
* Be sure to discard the discharged ink.
Attempting to clean the heads while discharged ink
remains may cause discharged ink to overflow from
the bottle.
5
INK CONTROL
HEAD WASH
Press the [ ] key to make the following screen
appear on the display.
3
INK CONTROL
EMPTY MODE
MENU
INK CONTROL
Press the [MENU] key and [ ] key to make the
following screen appear on the display.
2
Use the [ ] key to select [HEAD WASH], then press
the [ENTER] key.
4
EMPTY
DRAIN TANK