User`s manual

38
2 Basic Operation
When sending a material-cutting command from the computer to separate
the material automatically
On the computer, set the material-cutting command to "enabled."
2-7 When Not in Use...
When not in use, move the sheet loading lever
toward the back of the unit to leave the pinch
rollers in the raised state. The pinch rollers
may be deformed if allowed to remain in the
lowered state.
NOTICE
The material-separating location during
continuous printing
Start of the next printing operation
Location where separated
Margin (setting on the computer)
70 mm (2-13/16 in.)
70 mm
(2-13/16 in.)
End of printing
Sheet loading lever