User`s manual

22
2 Basic Operation
Fit the hole on the left side of the roll material all the way onto the left-hand media flange.
4
Close the front cover, and press the [SETUP] key. This
detects the width of the material and displays the
printable width.
9
Attach the media cover.
10
W 1234 mm
NORMAL BI-DIR
Top menu
The SETUP LED lights up
With the material pulled out from the roll stretched taut
with no slack, move the sheet loading lever toward
LOAD.
The pinch rollers lower to hold the material in place.
8
Grasp the front edge of the material at the front of the
machine and turn the media flanges at the back of the
unit to roll back the media.
When you roll back the material until the sensor comes
into view, a tight seal is formed between the material and
the platen, and the material is stretched taut.
7
Material
Sensor
Front
Pass the end of the material through the unit from back
to front.
Pull out material until the sensor is hidden from view.
6
Roll material
Right-hand media flangeLeft-hand media flange
Fit the right-hand media flange all the way into the hole on the right-hand side of the roll material, and tighten the retainer screw
to secure in place.
5
Sensor
Entire material
stretched taut