User`s guide

40
SONAR REAC Recording System User’s Guide
•
•
•
•
•
•
Playback Only
When this mode is selected, the monitoring device becomes the clock master for SONAR. This option allows
for the best playback performance without a physical clock connection between the monitoring device and the
REAC hardware. Selecting this option disables the Freewheel Options button.
Record Only
When this mode is selected, the monitoring device is not available for monitoring. This option is primarily used
for recording only without a physical clock connection between the monitoring device and the REAC
hardware. When Record Only mode is enabled, the Freewheel Options button is unavailable.
Other Panel settings and controls
REAC Status
On indicates that the SONAR workstation is connected to the REAC system and is receiving data. Off may
indicate a connection and/or communication problem between the REAC hardware and SONAR. For
example, the Ethernet cable may not be connected to the PC, or a part of the REAC system may have lost
power. This control works in real-time and will update its state if a connection change is detected from the
REAC System, even while the dialog is open.
REAC Inputs
By default, this control will be set to the highest number of inputs currently configured on your REAC
hardware. You can choose to set this value lower than the actual number of physical inputs, which will simply
expose a shorter list of inputs to SONAR.
Sample Rate
Indicates the REAC sample rate. If the REAC signal is not detected, this field will display the last sample rate
detected by the system.
Note: SONAR and the monitoring device must be set to the same sample rate as your REAC System
and/or V-Mixer.