Owner`s manual

Troubleshooting

Is the FA-66’s sample rate set to a rate other than 192 kHz?

If the FA-66’s sample rate select switch is set to 192 kHz, the digital output

connector and the digital input connector are not available.

Are your input/output devices connected correctly?

In order to play back audio/MIDI using the FA-66, you must make the appropriate

input/output device settings. For details on making these settings, refer to

“Audio

and MIDI settings”

(p. 19) or

“Driver settings”

(p. 30).

If you are using the 192 kHz sample rate on Windows XP, the FA-66 may not appear

in the Sounds tab of the Sounds and Audio Devices Properties dialog box. If so,

please update your system to Windows XP Service Pack 1.

Could the FA-66 have been connected when you started up the computer?

Start up the computer with the FA-66 disconnected, and then connect the FA-66.

Depending on the type of computer you are using, starting up the computer when

the FA-66 is already connected may cause operation to be unstable. In this case, start

up your computer and then connect the FA-66.

FA-66_e.book 52 ページ２００６年１月１２日　木曜日　午前１１時３２分