Owner`s manual

Troubleshooting

Are you attempting to install from a networked CD-ROM drive?

You cannot install from a networked CD-ROM drive.

Could the CD-ROM or the lens of your CD-ROM drive be dirty?

If the CD-ROM or the lens of your CD-ROM drive are dirty, the installer may not

work correctly. Use a commercially available CD cleaner or lens cleaner to clean the

CD-ROM and/or lens.

Are the power conservation settings of your computer turned off?

If power conservation settings are turned on for your computer, disable these

settings. (For details on how to disable them, refer to the owner’s manual of your

computer.)

Is there enough free space on your hard disk?

Delete unneeded files to increase the amount of free space.

After deleting the file(s), empty the recycling bin.

Is the FireWire (IEEE 1394) connector enabled on your computer?

Refer to the owner’s manual for your computer, and verify that the FireWire (IEEE

1394) connector of your computer is enabled. The driver cannot be installed unless

the FireWire (IEEE 1394) connector is enabled.

Does your computer or FireWire (IEEE 1394) repeater hub have a

sufficient power supply?

If you are using bus power, the FA-66 cannot be connected if insufficient power is

being supplied to it.

Check whether the following cases might apply.

• If you are using a notebook computer running on its battery, operation may be

unstable with some computers. If this is the case, connect your computer to its

AC adaptor.

• The power conservation mode of your computer may be limiting the power it

supplies to the FireWire (IEEE 1394) connector. Re-examine the settings of your

computer.

• The FA-66 cannot be used with some bus-powered repeater hubs (hubs that do

not have their own power supply). Use a self-powered hub (a repeater hub that

has its own power supply).

Does your computer meet the FireWire (IEEE 1394) specification?

Operation may be unstable if you are using a computer that does not electrically

meet the FireWire (IEEE 1394) specification. If so, you may be able to solve the

problem by connecting a FireWire (IEEE 1394) repeater hub that has its own power

supply.

FA-66_e.book 49 ページ２００６年１月１２日　木曜日　午前１１時３２分