Owner`s manual

38
Basic connections and settings
fig.digital
Connections
Connect your digital device to the digital input connector.
Sample rate select switch
Set this to match the sample rate of your digital playback device and the sample
rate of your recording software.
If you switch the FA-66’s sample rate, you must turn the power of the FA-66 off,
then on again to get the setting to take effect.
You cannot record digital signals if the 192 kHz setting is selected.
Digital input switch
Turn this on so that the FA-66 will synchronize to the digital signal being input
to the digital input connector.
When synchronized correctly, the sync indicator will light green. If this
indicator is blinking green, synchronization has not been achieved. In this case,
check that the sample rate of the connected digital device matches the sample
rate selected by the FA-66’s sample rate switch.
Direct monitor volume
This adjusts the monitor volume.
Adjusting the direct monitor volume will not affect the recording level.
Recording a digital signal
ON
Specify the sample rate
Set this to match the sample rate of
your digital playback device
CD/MD/DAT player,
hard disk recorder, etc.
FA-66_e.book 38 ページ ２００６年１月１２日 木曜日 午前１１時３２分