Owner`s manual

32
Installing the driver (Windows)
If you will be using the Windows Media Player application
with the FA-66, specify the input/output devices as
follows.
The method in which you make device settings will
depend on the software you are using. For details, refer to
the owner’s manual for your software.
1
Open the Sound, Speech, and Audio Devices
Properties dialog box.
1.
From the Windows start menu, choose Control
Panel .
2. In “Pick a category,” click Sound, Speech, and
Audio Devices .
3.
In “or Pick a Control Panel icon,” click the Sounds
and Audio Devices icon.
fig.sound
2
Click the Audio tab.
3
In the Sound
playback , Sound
recording , and MIDI
music playback
areas, click the Default
device field. From the
list that appears for
each field, choose the
device shown below.
4
Click [OK] to close the Sounds and Audio Devices
Properties dialog box.
This completes the audio and MIDI input/output settings.
Input/output device settings
Sound playback EDIROL FA-66 Out 1
Sound recording EDIROL FA-66 In 1
MIDI music playback EDIROL FA-66 MIDI OUT
Depending on your system,
the System icon may be
displayed directly in the
Control Panel (Classic view).
If so, double-click the System
icon.
If you are using sequencer
software, you will need to
make audio and MIDI device
settings from within your
software. For details, refer to
the owner’s manual for the
software you are using.
Each input/output device can
only be used by one software
application at a time;
multiclient usage is not
supported.
If you are using the 192 kHz
sample rate on Windows XP,
the FA-66 may not appear in
the Sounds tab of the Sounds
and Audio Devices Properties
dialog box. If so, please update
your system to Windows XP
Service Pack 1.
FA-66_e.book 32 ページ ２００６年１月１２日 木曜日 午前１１時３２分