Owner`s manual
26
Installing the driver (Windows)
11
A dialog box entitled
“Setup is now ready to install the
drivers”
appears.
Use a FireWire (IEEE 1394) cable to connect the FA-66 to
your computer.
1.
With the power switch turned off, connect the AC
adaptor to the FA-66.
2.
Plug the AC adaptor’s power cord into an AC outlet.
3.
Use a FireWire (IEEE 1394) cable to connect the FA-66
to your computer.
12
Turn on the power switch of the FA-66.
The
“Found New Hardware”
message appears near the
taskbar. Please wait.
13
A dialog box entitled
Welcome to the Found New
Hardware Wizard
appears. Make sure that the box
indicates
“EDIROL FA-66 Sub 1,”
choose
“Install the
software automatically (Recommended),”
and click
[Next]
.
14
A dialog box entitled
“Completing the Found New
Hardware Wizard”
appears.
Click
[Finish]
.
Once again, the
“Found New Hardware”
message appears
near the taskbar. Please wait.
fig.caution.eps
If the setting in the Driver
Signing Options dialog
box is not set to “Ignore,”
a dialog box like the
following will appear.
Click [Continue
Anyway] to continue
driver installation.
Once the connections have
b
een completed, turn on
power to your various devices
in the order specified. By
turning on devices in the
wrong order, you risk causing
malfunction and/or damage to
speakers and other devices.
This unit is equipped with a
protection circuit. A brief
interval (a few seconds) after
power up is required before
the unit will operate normally.
If the Found New Hardware
Wizard asks you whether you
want to connect to Windows
Update, choose “No” and then
click [Next].
FA-66_e.book 26 ページ ２００６年１月１２日 木曜日 午前１１時３２分