Owner`s manual

Before you begin using the FA-66 with your Macintosh (Mac OS X users)

Before you start up your software, use a FireWire (IEEE

1394) cable to connect the FA-66 to your computer, and

turn on the power of the FA-66.

If your software allows you to specify MIDI and audio

input/output settings, choose

EDIROL FA-66

. For details,

refer to the owner’s manual for your software. Also refer to

“Software settings”

(p. 40).

If you have turned on software

monitoring in your application, turn the

FA-66’s hardware monitoring (direct

monitor) off to prevent double monitoring

and to keep an audio feedback loop from

occurring.

Software settings

About the demo songs

The SampleSong folder on the included CD-ROM contains the following demo

songs. Please copy the demo songs to the hard disk of your Macintosh before

listening to them.

* The demo songs were produced at 48 kHz. You must set the FA-66’s sample rate to

48 kHz. You’ll need to cycle the power to the FA-66 after changing the sampling rate.

for Cubase folder

This folder contains the demo songs as Cubase VST song files (.all) and Cubase

SX project files (.cpr).

If you are using the Cubase SX demo version, the playback will not be correct

since some functionality (such as effects) will not be available.

for Logic folder

This folder contains the demo songs as Logic project files (.lso).

For the latest information,

please visit

http://www.edirol.com/

FA-66_e.book 23 ページ２００６年１月１２日　木曜日　午前１１時３２分