Owner`s manual

Before you begin using the FA-66

with your Macintosh

(Mac OS X users)

If you are using the FA-66 with Windows, please read

“Installing the driver (Windows)”

(p. 24).

If you’re using the FA-66 with Mac OS X, you don’t need to

install a driver.

Simply connect the FA-66 to your Macintosh as described

below.

With the FA-66 disconnected, start up your Macintosh.

Use a FireWire (IEEE 1394) cable to connect the FA-66 to

your Macintosh.

With the FA-66’s power switch off, connect the power

cord to it.

Plug the AC adaptor cable into an AC outlet.

Use a FireWire (IEEE 1394) cable to connect the FA-66

to your Macintosh.

Turn on the FA-66’s

power switch

The driver will be installed automatically.

Next, you need to make audio device and MIDI device

settings.

Once the connections have

een completed, turn on

power to your various devices

in the order specified. By

turning on devices in the

wrong order, you risk causing

malfunction and/or damage to

speakers and other devices.

This unit is equipped with a

protection circuit. A brief

interval (a few seconds) after

power up is required before

the unit will operate normally.