Owner`s manual

Front and rear panel

fig.front.eps_60

STEREO/MONO select switch (direct monitor section)

This selects whether the input signal is to be monitored in stereo (STEREO) or in

monaural (MONO). Turn this on ( pressed inward) if you want to monitor in

monaural.

For example, if you’ve connected a guitar only to INPUT 2/R, you would use the

monaural setting ( inward position). Even with the monaural (MONO) setting, the

audio signal being sent via FireWire (IEEE 1394) to the computer will be stereo.

10.

Direct monitor soft control switch (direct monitor mixer section)

Turn this on ( pressed inward) if you want to control the direct monitor mixer (see

block diagram

➔

front cover) from your ASIO 2.0 compatible software. If this is on,

your software will be able to control the monitor volume, pan, and on/off status of

each input jack.

If this is off, all settings of the direct monitor mixer will be ignored (= bypassed),

allowing you to monitor the input signals from all input jacks. This is convenient if

you want to check the connections while temporarily ignoring the software settings.

* This function is available only on Windows.

11.

Direct monitor volume (direct monitor section)

fig.direct-volume

This adjusts the monitor volume.

Turning this knob toward the left

(OUT1/2) will decrease the level of the

sound being input through the input

jacks. Turning the knob toward the

right (MONITOR) will decrease the

level of the sound being output from

your computer. At the center position,

the sound being output from your

computer and the sound being input

via the input jacks will both be at 100%

of their level.

2 7 8 11 13

1495 6 10 123

Volume

100%

MONITOR

OUT 1/2

FA-66_e.book 12 ページ２００６年１月１２日　木曜日　午前１１時３２分