Owner`s manual

11
Front and rear panel
4.
Peak/Limiter indicator
This indicates whether the signal being input via the combo input jacks (1) is
distorting, or whether the limiter is operating.
5. Power indicator
Lights when the power is on.
6.
Output indicator
This will light green if signals are being sent from the computer’s audio output
ports 1 and 2 (OUT 1/2).
(see block diagram ➔ front cover)
7.
Digital input switch
If you want to record a digital input, turn this on ( pressed inward). This lets the
FA-66 synchronize to an external digital device connected to the digital input
connector (25)
8.
Sync indicator
When the digital input switch (7) is on, this indicator shows the status of
synchronization with a digital device connected to the digital input connector
(25) . (external synchronization mode)
Limiter switch
Status
Limiter on
The indicator will function as a limiter indicator. When the input sig-
nal exceeds a certain level, the limiter will operate and the indicator
will light green.
Limiter off
The indicator will function as a peak indicator. Use the input sensi-
tivity knobs for each input jack to adjust the input level so that the
peak indicator does not light red. The red LED will light if the sound
distorts.
Lit Synchronized correctly.
Blinking
Not synchronized. Check that your digital device is correctly connected to
the digital input connector.
Also make sure that the connected digital device is set to the same sam-
pling frequency as that selected by the FA-66’s sample rate select
switch (18) .
FA-66_e.book 11 ページ ２００６年１月１２日 木曜日 午前１１時３２分