Owner`s manual

10
Front and rear panel
fig.front.eps_60
fig.jack-type_70
1.
Combo input jacks
These are analog audio input jacks with mic preamps. They
accommodate either XLR or phone plugs, allowing you to
connect a variety of equipment. Either balanced or unbalanced
signals may be connected.
Phantom power (48 V) is provided for XLR type connections,
allowing you to connect condenser mics that require phantom
power. In this case, turn on the phantom power switch
(19) located on the rear panel.
fig.XLR-TRS
* This instrument is equipped
with balanced (XLR/TRS) type
input jacks. Wiring diagrams for
these jacks are shown on the
right. Make connections after
first checking the wiring
diagrams of other equipment you intend to connect.
2.
Input sensitivity knobs
These adjust the input level of the signals input to the front panel combo input
jacks (1) .
3.
Input impedance select switch
This switch selects either high impedance (Hi-Z) or low impedance (Lo-Z) as the
type of device connected to the INPUT 2 phone jack of the combo input jacks
(1) . If you have connected a guitar or bass to this jack, select the high impedance
(Hi-Z) setting; if you have connected a mic, select the low impedance (Lo-Z) setting.
* Combo input jack INPUT 1 is fixed at low impedance (Lo-Z).
fig.front.eps
Front panel
2 7 8 11 13
1495 6 10 123
XLR plug
TRS phone
plug
(balanced)
Phone plug
(unbalanced)
1:GND
2:HOT
3:COLD
GND(SLEEVE)
HOT(TIP)
COLD(RING)
FA-66_e.book 10 ページ ２００６年１月１２日 木曜日 午前１１時３２分