User's Manual
Table Of Contents
- Contents
- Operation Guide
- Panel Descriptions
- Before You Play
- Various Settings (Function Mode)
- Basic Operation in Function Mode
- Adjusting the Keyboard Sensitivity (Key Touch)
- Changing the Way in Which the Sound Is Heard (Twin Piano Mode)
- Dividing the Keyboard for Two-Person Performance (Twin Piano)
- Specifying What the Transpose Will Affect (Transpose Mode)
- Transposing the Keyboard or Song (Transpose)
- Applying a Headphones 3D Ambience Effect to the Piano Sound (Headphones 3D Ambience)
- Matching the Pitch with Other Instruments (Master Tuning)
- Changing the Tuning Method (Stretch Tuning)
- Changing How the Pedals Work
- Specifying How the Bass Part Behaves (Leading Bass)
- Chord Recognition When Split Is On
- Preventing Doubled Notes When Connected to a Sequencer (Local Control)
- Copying a Song (Copy Song)
- Bluetooth Function
- Bluetooth Page-Turning/MIDI Switching
- Bluetooth Page-Turning Pedal Assignment
- Making the Power Automatically Turn Off After a Time (Auto Off)
- Saving the Settings (Memory Backup)
- Basic Operation in Function Mode
- Restoring the Factory Settings (Factory Reset)
- Specifying the Maximum Volume (Volume Limit)
- Using the Bluetooth® Functionality
- Troubleshooting
- Message List
- USING THE UNIT SAFELY
- IMPORTANT NOTES
°
Message List
Indication Meaning
E.01
The music le you attempted to save is read-only. It cannot be saved.
E.02
An error occurred while writing. It may be that the protect tab of the
external media is in the “Protect (write prohibit)” position, or that the
external media has not been formatted.
E.10
No USB ash drive connected. Connect a USB ash drive and try the
operation again.
E.11
There is insucient free space at the save destination. Either connect a
dierent USB ash drive, or delete unwanted data (song data) and try
the operation again.
E.14
An error occurred while reading. The USB ash drive may be damaged.
Connect a dierent USB ash drive and try the operation again. You may
also format the USB ash drive (p. 7).
E.15
The le could not be read. The data format is not compatible with the
unit.
E.16
The data could not be read fast enough during song playback. After
waiting several seconds, you may be able to play back the song by
pressing the [s] button once again.
E.18
This audio format is not supported. Please use WAV format, 44.1 kHz,
16-bit linear audio les.
E.30
The unit’s internal memory is full.
E.40
The unit cannot deal with the excessive MIDI data sent from the external
USB MIDI.
Reduce the amount of MIDI data sent to the unit.
E.51
There may be a problem with the system.
Repeat the procedure from the beginning. If it is not solved after you
have tried a number of times, contact the Roland service center.
E.65
The USB ash drive connector was subjected to excessive current.
Make sure that there is no problem with the external media, then turn
the power o, then on again.
---
The Panel Lock function is on (p. 9).
PU
When playing back a song, this is shown if the song starts on an upbeat.
Blinking
number
When the Auto O function is activated, the remaining time blinks
before the power turns o.
17