Owner's manual

EXR-5/EXR-3 MIDI Implementation
15
40 1x 0F 00 00 01 00, 01 Rx. HOLD1 OFF/ON 01 ON
40 1x 10 00 00 01 00, 01 Rx. PORTAMENTO OFF/ON 01 ON
40 1x 11 00 00 01 00, 01 Rx. SOSTENUTO OFF/ON 01 ON
40 1x 12 00 00 01 00, 01 Rx. SOFT OFF/ON 01 ON
40 1x 13 00 00 01 00, 01 MONO/POLY MODE Mono/Poly 01 Poly
(=CC# 126 01/CC# 127 00)
40 1x 14 00 00 01 00~02 ASSIGN MODE 0 = SINGLE
1 = LIMITED-MULTI 01 LIMITED-MULTI
2 = FULL-MULTI
00 at x=0 SINGLE (Drum Part)
01 at x≠0 LIMITED-MULTI
(Normal Part)
Single: If the same note is played multiple times in succession, the previously-sounding note will be completely silenced, and then the new note will be sounded.
LimitedMulti: If the same note is played multiple times in succession, the previously-sounding note will be continued to a certain extent even after the new note is sounded (default
setting).
FullMulti: If the same note is played multiple times in succession, the previously-sounding note(s) will continue sounding for their natural length even after the new note is sounded.
• ASSIGN MODE is the parameter that determines how voice assignment will be handled when sounds overlap on identical note numbers in the same channel (i.e., repeatedly struck
notes). This is initialized to a mode suitable for each Part, so for general purposes there is no need to change this.
40 1x 15 00 00 01 00~02 USE FOR RHYTHM PART 0 = OFF 00 at≠0 OFF (Normal Part)
1 = MAP1 01 at x=0 MAP1 (Drum Part)
2 = MAP2
• This parameter sets the Drum Map of the Part used as the Drum Part. The EXR-5/EXR-3 can simultaneously (in different Parts) use up to two Drum Maps (MAP1, MAP2). With the
initial settings, Part10 (MIDI CH=10, x=0) is set to MAP1 (1), and other Parts are set to normal instrumental Parts (OFF(0)).
Address(H)
Size(H) Data(H) Parameter Description Default Value (H) Description
40 1x 16 00 00 01 28~58 PITCH KEY SHIFT -24~+24 [semitones] 40 0 [semitones]
40 1x 17 00 00 02 08~F8 PITCH OFFSET FINE -12.0~+12.0 [Hz] 08 00 0 [Hz]
40 1x 18# Use nibblized data.
• PITCH OFFSET FINE allows you to alter, by a specified frequency amount, the pitch at which notes will sound. This parameter differs from the conventional Fine Tuning (RPN #1)
parameter in that the amount of frequency alteration (in Hertz) will be identical no matter which note is played. When a multiple number of Parts, each of which has been given a
different setting for PITCH OFFSET FINE, are sounded by means of an identical note number, you can obtain a Celeste effect.
40 1x 19 00 00 01 00~7F PART LEVEL 0~127 64 100
(=CC# 7)
40 1x 1A 00 00 01 00~7F VELOCITY SENSE DEPTH 0~127 40 64
40 1x 1B 00 00 01 00~7F VELOCITY SENSE OFFSET 0~127 40 64
40 1x 1C 00 00 01 00~7F PART PANPOT -64 (RANDOM), 40 0 (CENTER)
-63 (LEFT)~+63 (RIGHT)
(=CC# 10, except RAN-
DOM)
40 1x 1D 00 00 01 00~7F KEYBOARD RANGE LOW (C-1)~(G9) 00 C-1
40 1x 1E 00 00 01 00~7F KEYBOARD RANGE HIGH (C-1)~(G9) 7F G 9
40 1x 1F 00 00 01 00~5F CC1 CONTROLLER NUMBER 0~95 10 16
40 1x 20 00 00 01 00~5F CC2 CONTROLLER NUMBER 0~95 11 17
40 1x 21 00 00 01 00~7F CHORUS SEND LEVEL 0~127 00 0
(=CC# 93)
40 1x 22 00 00 01 00~7F REVERB SEND LEVEL 0~127 28 40
(=CC# 91)
40 1x 23 00 00 01 00, 01 Rx.BANK SELECT OFF/ON 01(00*) ON(OFF*)
• When “GM1 System On” is received, Rx.BANK SELECT will be set to OFF.
• When “GS RESET”, “XG Lite System On” or “GM2 System On” is received, Rx.BANK SELECT will be set to ON.
40 1x 24 00 00 01 00, 01 RX BANK SELECT LSB OFF/ON 01 ON
• When RX BANK SELECT LSB = OFF, Bank Select LSB (Bn 20 11) will be treated as 00H regardless of its value.
40 1x 2A 00 00 02 00 00~40 00~7F 7F PITCH FINE TUNE -100~0~+100 [cents]
(= RPN#1)
40 00 0
40 1x 2B#
40 1x 30 00 00 01 00~7F TONE MODIFY1 -64~+63 40 0
Vibrato Rate (=NRPN# 8/CC#76)
40 1x 31 00 00 01 00~7F TONE MODIFY2 -64~+63 40 0
Vibrato Depth (=NRPN# 9/CC#77)
40 1x 32 00 00 01 00~7F TONE MODIFY3 -64~+63 40 0
TVF Cutoff Freq (=NRPN# 32/CC#74)
40 1x 33 00 00 01 00~7F TONE MODIFY4 -64~+63 40 0
TVF Resonance (=NRPN# 33/CC#71)
40 1x 34 00 00 01 00~7F TONE MODIFY5 -64~+63 40 0
TVF&TVA Env.attack (=NRPN# 99/CC#73)
40 1x 35 00 00 01 00~7F TONE MODIFY6 -64~+63 40 0
TVF&TVA Env.decay (=NRPN# 100/CC#75)
40 1x 36 00 00 01 00~7F TONE MODIFY7 -64~+63 40 0
TVF&TVA Env.release (=NRPN# 102/CC#72)
40 1x 37 00 00 01 00~7F TONE MODIFY8 -64~+63 40 0
Vibrato Delay (=NRPN# 10/CC#78)
40 1x 40 00 00 0C 00~7F SCALE TUNING C -64~+63 [cents] 40 0 [cents]
40 1x 41# 00~7F SCALE TUNING C# -64~+63 [cents] 40 0 [cents]
40 1x 42# 00~7F SCALE TUNING D -64~+63 [cents] 40 0 [cents]
40 1x 43# 00~7F SCALE TUNING D# -64~+63 [cents] 40 0 [cents]
40 1x 44# 00~7F SCALE TUNING E -64~+63 [cents] 40 0 [cents]
40 1x 45# 00~7F SCALE TUNING F -64~+63 [cents] 40 0 [cents]
40 1x 46# 00~7F SCALE TUNING F# -64~+63 [cents] 40 0 [cents]
40 1x 47# 00~7F SCALE TUNING G -64~+63 [cents] 40 0 [cents]
40 1x 48# 00~7F SCALE TUNING G# -64~+63 [cents] 40 0 [cents]
40 1x 49# 00~7F SCALE TUNING A -64~+63 [cents] 40 0 [cents]
40 1x 4A# 00~7F SCALE TUNING A# -64~+63 [cents] 40 0 [cents]
Address(H)
Size(H) Data(H) Parameter Description Default Value (H) Description