Owner`s manual

6 TASCAM DM-3200 Ver 1.20
DM-3200 Ver1.20 Supplemental Manual
Assigning parameters to rotary encoders
Figure 12: OPTION>ENCODER MODE scree
You can assign parameters to the rotary encoders
using the four encoder mode keys (please refer to
the “Encoders” section on page 20 in the Owner’s
Manual).
In the previous versions of DM-3200, parameters were
pre-assigned as indicated next to each of the encoder
mode keys. In Version 1.20 you can select which
parameter is to be controlled by which of the encoder
mode keys.
Parameters are assigned on the ENCODER MODE
screen, which is a sub-screen newly added to the
OPTION screen.
1 Press the
OPTION
key to display the OPTION screen,
then use the
POD4
knob (or press the
OPTION
key
again) to display the ENCODER MODE sub-
screen.
2 Use the
cursor
key to select the encoder mode key to
assign a parameter from the list in the
EDIT TARGET
SELECT
section.
Starting at the top, row numbers 1-4 represent the
numbers of the encoder mode keys.
“
NONE
” means that the encoder key is pressed by
itself, “
SHIFT+
” means that the
encoder
key and the
SHIFT
key are pressed simultaneously, and “
CTRL+
”
means that the
encoder
key is pressed together with the
CTRL
key.
For example, if you want to assign a parameter to “the
topmost encoder mode key when it is pressed with
the
SHIFT
key,” select the field where “Row 1” and
“
SHIFT+
” cross.
The encoder mode which is currently assigned to the
selected encoder mode key will be highlighted in the
ENCODER MODE SELECT
section at the bottom of the
screen.
3 Using the
JOG/DATA
dial, select the encoder mode to
be assigned to the highlighted encoder mode key,
from the
ENCODER MODE SELECT
section.
NOTE
Depending on whether the surround mode is
set to STEREO or not, the options given in the
ENCODER MODE SELECT
section differ.
4 Press the
ENTER
key.
Assignment of the parameter is now complete and will
be displayed in the
EDIT TARGET SELECT
section.
NOTE
You need to perform the corresponding encoder
mode key operation in order to assign the set
parameter to a rotary encoder.
Cascade connection
DM-3200 Ver1.20 allows you to make a cascade con-
nection between two DM-3200 units.
Cascade connection overview
Two DM-3200 units that are connected by a cascade
connection can be operated as though they are one
mixer.
• STEREO buss, BUSS 1-16, AUX buss 1-8, and
SOLO buss can be shared when the sharing func-
tion is set to
ON
in the CASCADE screen.
• The audio clock is shared by the two units.
• Timecode is shared to synchronize the two units.
• Various settings and operations can be interlocked
between the two units. Please refer to the “Settings
and Operations that can be interlocked” section on
page 7 of this supplement.
Master/slave setting
You need to set one DM-3200 to be the cascade mas-
ter and the other to be the cascade slave. Any set-up
that affects the operation of the system as a whole will
be performed on the cascade master.
• An audio clock source is selected from the clocks
fed to the cascade master. You cannot select the au-
dio clock source on the cascade slave.
• Timecode fed to the cascade slave cannot be used
as the synchronization source.
• The cascade connection can be turned ON and OFF
only on the cascade master.
• When the cascade connection is
ON
, the parameter
set-ups on the cascade master (parameters to be
interlocked) are reflected on the cascade slave.
Continued on the next page