Owner`s manual

TASCAM DM-3200 Ver 1.20 5
DM-3200 Ver1.20 Supplemental Manual
Figure 10: MIDI MIXER screen
MIDI Volume (Control Change 7) is frequently used.
This allows the DM-3200 to remotely control the
sound volume of up to 16 external MIDI devices. This
is only possible when Layer Status is set to
REMOTE
and the MIDI FADER screen is currently showing or
was the last EXT.CTRL screen displayed.
When a Control Change message is received from an
external MIDI device, the value will be reflected in the
fader of DM-3200.
MIDI mixer
You can send MIDI Control Change messages to
external MIDI devices using the
POD
knobs, fader and
the
MUTE
key of the DM-3200. In the default setting,
they control pan, fader, and mute respectively.
This operation is possible only when the Layer Status
is set to
REMOTE
and the MIDI MIXER screen is cur-
rently showing or was the last EXT.CTRL screen
displayed. The screen will show “REM PAN” for the
encoder mode, and the encoders will control the pan
data.
When a Control Change message is received from an
external MIDI device, the value will be reflected in
DM-3200’s
POD
knobs, fader, and the
MUTE
key.
NOTE
When the Layer Status is set to
REMOTE
the pan
value is displayed on, and can be controlled with
the rotary encoders.
Changing the assignment
You can change the MIDI channel, Control Change
number, and ON/OFF status that are assigned to each
of the
POD
knobs, fader, and the
MUTE
key. Changes are
made on the MIDI>CTRL.CHANGE screen.
Figure 11: MIDI>CTRL.CHANGE screen
To display this screen, either press the
MIDI
key fol-
lowed by the
POD3
key (or keep pressing the
MIDI
key),
or move the cursor to the
Jump to SCREEN
button at the top right on the MIDI MIXER screen,
and press the
ENTER
key.
Use the
POD4
knob to select the key whose assigned
function is to be changed (
FADER
,
PAN
or
MUTE
) in the
TARGET
section on the right of the screen.
You will see a chart showing MIDI channel, Control
Change number, and ON/OFF status of the selected
key (channel 1-16) on the left of the screen.
Use the
cursor
key to select the item to be set, select the
value using the
JOG/DATA
dial, then press the
ENTER
key
to set the value. When you are changing the ON/OFF
status, press the
ENTER
key.
NOTE
If there is more than one key that is assigned to
the same MIDI channel, you cannot assign the
same Control Change number to both of them.
A Control Change number can be selected from
the following: 1-5, 7-31, 64-95.
When ON/OFF status is set to
ON
, a check mark
appears in the check box. When it is
OFF
, the box
is blank. In the figure 11, all the channels are set
to ON.
You cannot operate the MIDI control of the
channel pan when the surround mode is not set
to STEREO.
Continued from the previous page