Owner`s manual

10 TASCAM DM-3200 Ver 1.20
DM-3200 Ver1.20 Supplemental Manual
Additional dynamic automation
parameters
The following parameters can now be captured and
re-played by the dynamic automation function of
DM-3200 (please see “Automated Controls” on the
page 4 of the DM-3200 Automation Guide).
• Image
Image parameter of the linked channel (please see “Pan
and balance settings” on page 71 of the DM-3200
Owner’s Manual).
• Effect
Common effect parameters (
TYPE
,
INPUT
,
MIX
,
BYPASS
,
OUTPUT
) and TASCAM effect parameters (please
see “Setting up the effects” on page 82 of DM-3200
Owner’s Manual).
• Assignments
This includes, in addition to the buss assignment and
stereo buss assignment, the AUX 1-2 assignment
from the BUSS and stereo buss, surround assignment
and ON/OFF setting of CSP/LFE speakers (please
see “Channel-to-buss assignment” on page 51 and
“Assigning channels to surround busses” on page 75
of the DM-3200 Owner’s Manual).
NOTE
When any of the above mentioned parameters
is a continuous variable, the Revert function is
applied to it.
NOTE
On the AUTO CONFIG screen, each of these
additional parameters is related to an item as
shown below (please see “AUTO CONGIG” on
page 14 of the DM-3200 Automation Guide).
Expanded dynamic automation function
parameter item
IMAGE
Assign Swtch
Effect 1 parameters
Effect 2 parameters
PAN/BAL
BUSS ASSIGN
EFFECT 1
EFFECT2
Additional parameters that are re-played
as Initial Status
The following parameters are now captured and
re-played as the Initial Status of the automation
(please see “Initial Status” on page 32 of DM-3200
Automation Guide).
With these additions, all of the parameters that can be
stored as snapshots are now captured and re-played as
the Initial Status.
Trigger source of the compressor
Trigger source of the gate
ROUTING>INPUT screen setting
ROUTING>OUTPUT screen setting
ROUTING>INSERT screen setting
Pan mode setting
Surround pan mode setting
Direct assignments setting
Pan gang button setting
Digital trim value setting
Phase setting
Mono switch setting
Channel delay value setting
Pre/post setting of the channel delay
Level setting of BUSS/AUX signal to stereo buss
Pan setting of BUSS/AUX signal to stereo buss
Settings prohibited to change during
automation re-play
The following mixer settings cannot be changed while
automation data is being re-played.
Surround mode
Grouping setting
Channel link setting
Pan switch setting [Set by
SHIFT + OUTPUT ASSIGN
]
If you try to change the above settings, a popup win-
dow will appear with below message and the opera-
tion will be denied.
cannot do this
while automation is running.