Specifications

48
Menu Function Range Default
CONTRAST This changes the contrast of the display. 5 to 1 5
TEST This changes the cutting-test pattern carried out when TYPE1/TYPE2 TYPE1
PATTERN you press the [TEST CUT] key.
This performs an ordinary cutting test with [TYPE 1].
For thin materials or cases where graphics are too
small to obtain good cutting results with [TYPE 1],
make the setting for [TYPE 2].
DEMO CUT This performs an operation check when the CX-500/ ––
400/300 is not working correctly.
AUTOCUT AUTOCUT This selects whether the material-cutoff command is DISABLE/ENABLE DISABLE
MENU COMMAND enabled or disabled.
When set to [ENABLE], material cutoff is performed
automatically when a material-cutoff command is sent
from the computer.
Pressing the [SHEET CUT] key performs material
cutoff regardless of whether the setting is [ENABLE] or
[DISABLE].
AUTOCUT This sets the [AUTOCUT] (material cutoff) speed. 40 to 85 cm/s 50 cm/s
SPEED Set this to a suitable speed for the loaded material. (1cm/s step)
MARGIN This sets the amount of margin from the cut edge of the 5 to 50 mm 30 mm
material for the next starting point for cutting after (5mm step)
cutting off the material.
AUTOCUT This sets the number of times material cutoff is 1/2 1
PASSES performed (once for [1] or twice for [2]). When working
with thicker material or other material that's difficult to
cut, set this to [2]. Pressing the [SHEET CUT] key once
performs material cutoff the number of times set here.
COMMAND COMMAND This selection enables the type of instructions that are AUTO/ AUTO
MENU MODE understood by the unit. You can set the unit to accept MODE1/
either CAMM-GL III mode 1 instructions or mode 2 MODE2
instructions.
When set to [AUTO], the CX-500/400/300 automatically
detects the type of instructions first received after
turning on the power, and sets itself to accept those
instructions.
To change the type of instructions, first change the
setting, then switch the power to the unit off and back
on again.
VS To perform cutting at the speed determined by a VS DISABLE/ENABLE DISABLE
COMMAND command (tool speed setting command) sent from the
computer, set this to [ENABLE]. When set to
[DISABLE], cutting is performed using the values for
[SPEED] and [UPSPEED].
!FS To perform cutting at the blade force determined by an DISABLE/ENABLE DISABLE
COMMAND FS command (tool force setting command) sent from
the computer, set this to [ENABLE]. When set to
[DISABLE], cutting is performed using the values for
[FORCE].
TYPE 1 TYPE 2