Français Owner’s Manual Bedienungsanleitung Guide d’utilisation Manuale dell'utente Manual del usuario Manual do proprietário Gebruikershandleiding English 午後６時７分 Deutsch 金曜日 Português Español Italiano I 202 Copyright © 2009 ROLAND CORPORATION All rights reserved. No part of this publication may be reproduced in any form without the written permission of ROLAND CORPORATION. Nederlands cube-80x.
cube-80x.
金曜日 午後６時７分 Owner’s Manual English cube-80x.book 1 ページ ２００８年１２月１２日 Before using this unit, carefully read the sections entitled: “IMPORTANT SAFETY INSTRUCTIONS”, “USING THE UNIT SAFELY” (p. 2) and “IMPORTANT NOTES” (p. 4). These sections provide important information concerning the proper operation of the unit. Additionally, in order to feel assured that you have gained a good grasp of every feature provided by your new unit, Owner’s Manual should be read in its entirety.
cube-80x.book 2 ページ ２００８年１２月１２日 金曜日 午後６時７分 USING THE UNIT SAFELY About WARNING and CAUTION Notices About the Symbols Used for instructions intended to alert the user to the risk of death or severe injury should the unit be used improperly. ALWAYS OBSERVE THE FOLLOWING 001-50 008a • • Connect mains plug of this model to a mains socket outlet with a protective earthing connection.
cube-80x.book 3 ページ ２００８年１２月１２日 金曜日 午後６時７分 USING THE UNIT SAFELY 101a • • Add • A small amount of heat will radiate from the unit during normal operation. Do not use the unit in an area with less than the air space shown below. The unit should be located so that its location or position does not interfere with its proper ventilation. ...........................................................................................................
cube-80x.book 4 ページ ２００８年１２月１２日 金曜日 午後６時７分 IMPORTANT NOTES Power Supply 301 • Do not connect this unit to same electrical outlet that is being used by an electrical appliance that is controlled by an inverter (such as a refrigerator, washing machine, microwave oven, or air conditioner), or that contains a motor. Depending on the way in which the electrical appliance is used, power supply noise may cause this unit to malfunction or may produce audible noise.
cube-80x.book 5 ページ ２００８年１２月１２日 金曜日 午後６時７分 Main Features ● A high-performance guitar amp equipped with a 30-cm (12-inch) speaker and delivering 80 watts of output ● Switchable between two-channels: JC CLEAN and LEAD Switchable using a footswitch pedal (optional BOSS FS-6, FS-5U, or FS-5L). A total of ten COSM amp types are built in, including a clean amp for the JC CLEAN channel and acoustic, crunch, high-gain, and the original Dyna Amp for the LEAD channel.
cube-80x.book 6 ページ ２００８年１２月１２日 金曜日 午後６時７分 Panel Descriptions Control Panel INPUT Jack Connect your guitar here. SELECT Switch This switches between the JC CLEAN and LEAD channels. The indicator shows you which channel is selected. JC CLEAN Channel This models the Roland JC-120. This is a sound that readily extends up to the treble range. This amp is ideal for creating sounds in combination with a multi-effects device.
cube-80x.book 7 ページ ２００８年１２月１２日 金曜日 午後６時７分 Panel Descriptions METAL STACK This is modeled on the Peavey EVH 5150. This is a high-gain amp, so you can get heavy distortion and sustain even at low volumes. R-FIER STACK This super high-gain amp is modeled on the Mesa/Boogie Rectifier. This is a super high-gain amp. It’s capable of producing slash metal, grunge, and a wide range of other lead sounds. DLX COMBO BRIT COMBO This is modeled on the Vox AC-30TB.
cube-80x.book 8 ページ ２００８年１２月１２日 金曜日 午後６時７分 Panel Descriptions SOLO Function PRESENCE Knob This gives the midrange and high end a more lustrous contour. This is effective when you want to make the sound more airy and open. This lets you save the panel settings for sounds you create with the LEAD channel (such as amp type, gain, equalizer, and various effects) and call them up later. EFX (Effects) Knob On this unit, this function is called “SOLO.
cube-80x.book 9 ページ ２００８年１２月１２日 金曜日 午後６時７分 Panel Descriptions TAP Switch DELAY/LOOPER Knob When the knob is positioned at WARM or CLEAR, you can use this to adjust the delay time. Adjusts the delay time LOOPER Starts and stops Looper recording and playback Refer to “Using the LOOPER Function and Delay at the Same Time” (p. 18). Description This is a feedback delay with a warm analog-delay feel. Turn the knob clockwise to increase the effect sound.
cube-80x.book 10 ページ ２００８年１２月１２日 金曜日 午後６時７分 Panel Descriptions s POWER Switch Turns the power on and off. 941 * Once the connections have been completed (p. 11), turn on power to your various devices in the order specified. By turning on devices in the wrong order, you risk causing malfunction and/or damage to speakers and other devices. 1. Make sure that all volume controls on this unit and connected devices are set to 0. 2.
cube-80x.book 11 ページ ２００８年１２月１２日 金曜日 午後６時７分 Panel Descriptions Rear Panel Recorder, etc. English MP3/CD Player, etc. Speaker Cable INPUT 1 2 Deutsch External Speaker 3 4 6 7 Français 8 5 Italiano PCS-31 BOSS FS-6, etc. DELAY/LOOPER MUTE TAP/REC/PLAY/DUB REVERB EFX SOLO CH SELECT Foot Switches Headphones Mixer, etc. * To prevent malfunction and/or damage to speakers or other devices, always turn down the volume, and turn off the power on all devices before making any connections.
cube-80x.book 12 ページ ２００８年１２月１２日 金曜日 午後６時７分 Panel Descriptions Connection and Settings When Using an FS-5L or Latch-type Footswitch Pedal When you’re using the FS-6 or FS-5L, you can determine whether the footswitch pedal is on or off by checking its indicator light. Jack Jack Jack TIP: TAP/REC/PLAY/DUB For DELAY: Adjusts the delay time For LOOPER: LOOPER operation (p.
cube-80x.book 13 ページ ２００８年１２月１２日 金曜日 午後６時７分 Panel Descriptions Important Notes When Using a Latch-type Footswitch Pedal English Normally, the on/off state of the footswitch pedal takes precedence over the control panel for switching EFX, delay, or reverb on and off. However, the on or off states stored in memory using the SOLO function take precedence when saved SOLO-function panel settings are called up.
cube-80x.book 14 ページ ２００８年１２月１２日 金曜日 午後６時７分 Panel Descriptions Connection and Settings When Using an FS-5U or Momentary-type Footswitch Pedal Jack Jack Jack TIP: TAP/REC/PLAY/DUB For DELAY: Adjusts the delay time For LOOPER: LOOPER operation (p.
cube-80x.book 15 ページ ２００８年１２月１２日 金曜日 午後６時７分 Panel Descriptions EXT SPEAKER Jack When connecting to an external speaker, make sure the speaker conforms to the following specifications. Impedance: 8 ohms or less Allowable power input: 80 watts or greater Add * No sound is output from this unit’s speaker or any external speaker when the RECORDING OUT/PHONES jack is in use.
cube-80x.book 16 ページ ２００８年１２月１２日 金曜日 午後６時７分 Using the SOLO Function You can save and call up the panel settings (those enclosed by the line in the figure) for sounds you create with the LEAD channel. On this unit, this function is called “SOLO.” By default, “Loud Metal” (p. 20) sample settings are saved in the SOLO function. * The VOLUME setting for the LEAD channel is not saved. * The LOOPER settings and the recorded phrase are not saved.
cube-80x.book 17 ページ ２００８年１２月１２日 金曜日 午後６時７分 Using the LOOPER This lets you record a phrase you play, and play it back any number of times. You can also use it to overdub a recorded phrase. 3. Start playing the guitar. If the unit is in recording standby, the TAP switch lights up and recording starts. * The recorded phrase is deleted when the unit is turned off. * Unauthorized recording, distribution, sale, lending, public performance, 4.
cube-80x.book 18 ページ ２００８年１２月１２日 金曜日 午後６時７分 Using the LOOPER Overdubbing the Phrase Deleting the Phrase 1. 1. Press the TAP switch or depress the TAP/REC/ PLAY/DUB footswitch pedal to play back the phrase. The TAP switch lights in green and loop playback of the phrase starts. While phrase playback is stopped (and the TAP switch is flashing green), press and hold the TAP switch or the TAP/REC/PLAY/DUB footswitch pedal for approximately 2 seconds or longer.
cube-80x.book 19 ページ ２００８年１２月１２日 金曜日 午後６時７分 Using the Tuner Function This unit is equipped with a tuner function. In addition to manual tuning, you can also use it as a chromatic tuner. * 3. Play a single note on the open string that you want to tune. Tune the string until the green indicator lights. Use manual tuning when the strings are substantially out of tune (such as after changing strings). Flat Pitch is correct Lights red Lights green Sharp Press the TUNER button. * 2.
cube-80x.book 20 ページ ２００８年１２月１２日 金曜日 午後６時７分 Appendices Sample Settings * For information on how to set the delay time, refer to “DELAY/LOOPER Knob (p. 17).” Loud Metal Delay time = approx. 600 ms (reference) This sound produces heavy low-end reverberations when lower strings are played while muted, and airy sustain when chords are played. Playing with a humbucking rear pickup produces even more extreme distortion.
cube-80x.book 21 ページ ２００８年１２月１２日 金曜日 午後６時７分 Appendices Tube Crunch By adjusting the volume knob on the guitar together with the GAIN knob setting, adjusting the GAIN knob so that the amount of distortion changes naturally depending on your picking dynamics with little change in volume, you can obtain sound with a broad range of expressiveness.
cube-80x.book 22 ページ ２００８年１２月１２日 金曜日 午後６時７分 Appendices Rockabilly Slap This is the slapback-echo sound used in rockabilly and country. Delay time = 90 ms The BLACK PANEL amp produces a clean sound that is bright and sweet, with a powerful midrange and high end supported by a thick bass. By making the low and high ends more prominent while keeping them balanced, and also suppressing the midrange if the situation calls for it, you can bring out the dazzling resonance of the guitar even more beautifully.
cube-80x.
cube-80x.
cube-80x.
cube-80x.book 3 ページ ２００８年１２月１２日 Information AFRICA EGYPT Al Fanny Trading Office 9, EBN Hagar Al Askalany Street, ARD E1 Golf, Heliopolis, Cairo 11341, EGYPT TEL: (022)-418-5531 REUNION Maison FO - YAM Marcel 25 Rue Jules Hermann, Chaudron - BP79 97 491 Ste Clotilde Cedex, REUNION ISLAND TEL: (0262) 218-429 SOUTH AFRICA T.O.M.S. Sound & Music (Pty)Ltd. 2 ASTRON ROAD DENVER JOHANNESBURG ZA 2195, SOUTH AFRICA TEL: (011)417 3400 Paul Bothner(PTY)Ltd.
cube-80x.
cube-80x.
cube-80x.
