User`s manual

87
User's Reference
Meaning
- With [PRINT-CUT ADJ.] set to [AUTO], crop
marks cannot be detected.
- The [BASE POINT] key was pressed during
material setup to make the setting for auto-
matic detection of crop marks, but crop marks
cannot be detected.
An attempt was made to perform a printing or
cutting test outside the printing or cutting area.
The main power switch was turned off without
first turning off the sub power with the
[POWER] key.
Action
Load the material at the correct position and
perform detection of crop marks again.
Perform the printing or cutting test inside the
printing or cutting area.
Press the [POWER] key to turn off the sub
power, then turn on the power again.
Error messages
CROPMARK ERROR
NOT FOUND
CURSOR POS. ERROR
OUT OF AREA
ILLEGAL SHUTDOWN
TURN OFF POWER