User`s manual

76
User's Reference
Default
value
Setting
range
FunctionSubmenu
Top
menu
— ——INK LEFT This shows the amount of ink left after each of the ink cartridges has
been installed.
The fewer the markers ("
"), the less ink is left.
* If a partially used ink cartridge is removed and reinstalled, or if a
partially used ink cartridge is installed, the cartridge is "read" as
unused, and the displayed amount of remaining ink is not true.
For more information, see "Maintenance -- Check how much ink
remains."
COMMAND
VS
COMMAND
!FS
COMMAND
[VS COMMAND]
ENABLE/
DISABLE
[!FS COMMAND]
ENABLE/
DISABLE
ENABLE
This setting makes cutting conditions set with a software program
take priority. When set to [DISABLE], cutting is performed using the
values set with the CJ-500.
[VS COMMAND]: To perform cutting, set the speed determined by a
VS command (tool speed setting command) sent from the computer,
set this to [ENABLED].
[!FS COMMAND]: To perform cutting set the tool force determined
by an !FS command (tool force setting command) sent from the
computer, set this to [ENABLED].
SLEEP 15 min
This sets the time that elapses before the unit enters the SLEEP mode.
The SLEEP mode is enabled when the CJ-500 has been inactive for a
specified time. (When in the SLEEP mode, the POWER LED flashes
once per second.)
To release the SLEEP mode...
- Touch any key on the control panel. - Send data from the computer.
- Open the front cover. - Move the sheet loading lever toward the back of the unit.
— NONE/15
min to
120 min
(In steps of
15 min)
AUTO
SHEET CUT
— ENABLE/
DISABLE
ENABLEThis selects whether the material-cutting command is enabled or
disabled.
When set to [ENABLED], the material is cut automatically when the
computer sends a material-cutting command.
For more information, see "Remove the Material -- Cut the material
from the roll -- When sending a material-cutting command from the
computer to separate the material automatically."
HEAD
CLEANING
MEDIUM
POWERFUL
——You can use the [TEST PRINT] key to perform a printing test and
check the printing quality before starting to print. This also cleans the
printing heads if there is a problem in the printing test.
Normally cleaning is performed by pressing the [CLEANING] key on
the control panel, but if doing so doesn’t correct the problem, use this
menu to perform cleaning.
Because cleaning subjects the head to wear and consumes ink, it should
only be performed when absolutely necessary.
Performing cleaning from the [POWERFUL] menu in particular
subjects the head to early wear and used up large amounts of ink.
[MEDIUM]: This is used when performing cleaning by pressing the
[CLEANING] key does not correct the problem. After cleaning, carry
out a printing test to make sure there are no problems with printing
quality.
[POWERFUL]: Used when performing cleaning with [MEDIUM]
several times does not restore the printing quality. After cleaning,
carry out a printing test to make sure there are no problems with
printing quality.
For more information, see "MAINTENANCE -- Cleaning the Printing
Heads."