User`s manual

73
User's Reference
Default
value
Setting
range
FunctionSubmenu
Top
menu
Key
—— ——This cuts off the material at the present location of the
blade tip. Press this to cut off the portion already
printed or cut from the roll.
You cannot sever a piece of material while printing or
cutting is in progress.
For more information, see "Removing the Material."
—— ——This enters the menu mode.
When a menu is displayed, the [
] and [ ] keys
move to the next menu,
the [
] moves to a submenu, and the [ ] key
moves to the previous screen.
—— ——This is used to accept, execute, or save the item shown
on the display.
—— ——These move the material and the carriage.
When a menu is displayed, these move among the
menu items.
—— ——Holding down this key for 1 second or longer performs
a printing test in an area of approximately 54 mm x 18
mm (2.13 in. x 0.71 in.).
Before starting to print, you can carry out a test printing
to check the printing quality. For more information, see
"Setup for Printing -- Test Printing."
If there is a problem with the state of the heads, such as
dot drop-out, perform head cleaning.
—— ——Holding down this key for 1 second or longer performs
cleaning for the printing heads.
You can perform cleaning while in any state.
For more information, see "Maintenance -- Cleaning
the Printing Heads."
—— ——Holding down this key for 1 second or longer performs
a cutting test in an area of approximately 20 mm x 20
mm (0.79 in. x 0.79 in.).
For more information, see "Setup for Cutting -- Test
Cutting"
If there are problems with the quality of cutting results
for the material, press the [CUT CONFIG] key and
adjust the cutting conditions.
MENU
LANGUAGE
— ENGLISH
JAPANESE
ENGLISHThis sets the language for screen messages. You can
select either English or Japanese.
+
—— ——This forces the tool to move up or down.