User`s manual

64
User's Reference
Setting the Page Margins
This sets the margin between pages.
When outputting a number of pages continuously, you can establish a margin between the pages.
You can set this in a range of 0 mm to 100 mm (in 10 mm steps).
This is set at 20 mm when shipped from the factory.
[ When the material-cutting command is enabled ]
Start of the next output
End of output
Margin (value set for [PAGE MARGIN])
Start of the next output
End of output
Margin (value set for [PAGE MARGIN])
Location where separated
35 mm
(1-1/8 in.)
35 mm (1-1/8 in.)
[ When the material is not cut off ]
Press the [MENU] key and [ ] key to make the
following screen appear on the display.
1
Press the [ ] key to make the following screen
appear on the display.
2
Use the [ ] and [ ] keys to set a margin, then press
the [ENTER] key.
3
MENU
PAGE MARGIN
PAGE MARGIN
20mm 20mm
0 to 100 mm
(In steps of 10 mm)
PAGE MARGIN
20mm 10mm
- When separating the material with the margin set at [0], the position where the material is separated and the end of
printing/cutting may not match.
- When performing continuous printing with the margin set at [0], image quality just after starting to print may be
poor on the second page or after. Also, dot drop-out or overlap may occur at the page borders.
35 mm (1-1/8 in.)