User`s manual

58
User's Reference
When printing is finished press the [SET UP] key,
remove the material and carry out lamination (or
whatever further processing needs to be done).
Load the material at the same pinch-roller positions
used during printing, then press the [SETUP] key.
2
Follow steps 1 through 4 for making the setting
automatically on the previous pages, then perform
printing.
1
Adjusting Manually
Install a blade on the cutting carriage.
3
Set the base point.
Use the arrow keys to align the blade at the place on
the lower-right crop mark shown in the figure, then
press the [BASE POINT] key.
4
Set the align point.
Use the arrow keys to align the blade at the place on
the lower-left or upper-right crop mark shown in the
figure, then press the [ALIGN POINT] key.
5
Send the cutting data from the computer.
6
Base point
Align the
center of
the blade
with the
base point
or the align
point.
Align point
Align point
*The align point cannot be set to both the lower left and upper right points.
*The align point cannot be set if the angle between the base point and the align
point is 5 degrees or more.
*Crop marks drawn with computer programs cannot be used as crop marks
by this machine.
Center of the
blade
Center of the
blade
Center of the
blade