User`s manual

57
User's Reference
Use the [ ] and [ ] keys to select the type of
material that is loaded, then press the [BASE POINT]
key.
7
When the screen shown in the figure appears, use the [
] and [ ] keys to choose [BASE] or [BASE-
ALIGN], then press the [ENTER] key.
8
Press the [SET UP] key.
The crop marks printed in step 4 are detected auto-
matically, and the base point and the align points (if
you selected [BASE-ALIGN]) are set and adjusted.
9
Send the cutting data from the computer.
10
*The align point cannot be set if the angle
between the base point and the align point is
5 degrees or more.
*Crop marks drawn with computer programs
cannot be used as crop marks by this
machine.
*Depending on the kind of lamination that’s
performed, the crop marks may not be read
accurately.
SETUP SHEET
ROLL EDGE PIECE
AUTO CROP MARK
BASE
BASE :Only the base point is detected.
BASE-ALIGN :The base point and the align points
are detected.
Align point
Align point
Base point