User`s manual

User's Reference

Remove the Printed Material, then Reload the Material and Perform Cutting

Setting the Base Point and the Align Point

This feature is for performing position alignment in cases where printing is performed, after which the material removed from the

machine for further processing (such as laminating), then again loaded on the machine for cutting.

When cutting off a piece of material that has been printed from a roll, then again loading it as [PIECE], make sure

there is 80 mm (3-3/16 in.) or more from where printing ended to the material’s end edge (the place where cut off

from the roll).

When cutting off the material automatically, set a page margin of 80 mm (3-3/16 in.) or more (see “Setting the Page

Margins”).

Adjusting Automatically

Press the [MENU] key and [ ] key to make the

following screen appear on the display.

Press the [ ] key to make the following screen

appear on the display.

Use the [ ] key to select [ENABLE], then press the

[ENTER] key.

When printing is finished press the [SET UP] key,

remove the material and carry out lamination (or

whatever further processing needs to be done).

After processing, load the material at the same pinch-

roller positions used during printing.

Send the printing data from the computer.

Three crop marks are automatically printed on the left

and right areas at the front edge of the material.

Use the [ ] and [ ] keys to position the material so

that the lower-right crop mark lies on an imaginary

line extending from the blade tip.

CROP MARK

DISABLE DISABLE

CROP MARK

DISABLE ENABLE

* Setting [CROP MARK] to [ENABLE] makes the

output area 25 mm (1 in.) narrower.

Crop marks

Rear

Front

Cutting

carriage

Imaginary

line from the

blade tip

Lower-right crop mark

Blade tip