User`s manual

37
Opening the front cover while printing is in progress causes an emergency stop. This means that printing may
not be carried out correctly even if operation is resumed, due to drop-out or misalignment of the image.
To pause printing for any other reason than an emergency stop, press the [PAUSE] key.
Note pressing the [PAUSE] key to pause operation may result in differing image quality before and after the
pause. It is a good idea to avoid pausing operation while printing is in progress whenever possible.
NOTICE
If you leave the print head uncapped for a long time (for example, open the front cover while print head is in
the middle of platen), print heads may get clogged and, in some cases it results in unrecoverable damage to the
print head.
Press the [PAUSE] key.
To resume printing
Press the [PAUSE] key.
The PAUSE LED lights up
Pausing Printing or Cutting Operations
The PAUSE LED goes out
Downloading Printing/Cutting Data
Downloading Printing/Cutting Data
Printing or cutting is started when data is sent from the computer.
If the top menu isn't displayed, printing or cutting doesn't start even when data is sent from the computer.
Conditions for starting printing or cutting
The material must be already set up (with the SETUP LED lighted),
and the display must show the top menu.
If another menu screen is displayed, press the [SETUP] key to go back to the top menu.
(Pressing the [SETUP] key when another menu screen is displayed does not cancel the set-up for the material.)
Top menu
W1234mm L ---mm
FINE BI-DIR