User`s manual

25
From the front of the machine, pull the center of
material straight out toward the front. Without letting
any part of the entire piece of material pulled out to
become slack, move the sheet loading lever all the
way to “LOAD.”
The pinch rollers lower to hold the material in place.
8
Press the [SETUP] key. This detects the width of the
material and shows the printable width on the display.
*When [EDGE] is selected in step 9, the width of
the loaded material is detected, then the front
edge of the material is aligned with the print-start
location.
10
Align the left- and right-hand stoppers with the width
of the material and tighten the screws to secure in
place.
7
Rear
Roll material
Stopper
Screw
Media flange
Rear
Entire material
stretched taut
Close the front cover.
Use the [
] and [ ] keys to select [ROLL], then
press the [ENTER] key.
*If printing is to be performed from the edge of
the material, select [EDGE] (If [EDGE] does not
appear, set [EDGE SENSE] to [ENABLE]).
9
Top menu
W1000mm L ---mm
FINE BI-DIR
The SETUP LED lights up
If a pinch roller is positioned over an area where there is
no grit roller, the message shown below appears when
you press the [SETUP] key.
SETUP SHEET
ROLL EDGE PIECE
PINCHROLL ERROR
INVALID LEFTPOS
or [RIGHT]
Setup for Printing
* If there is any slack in the loaded material, the material may
move at an angle and come loose from the pinch rollers.
Check the positioning of the pinch rollers and make
sure they are aligned at the correct positions.
Sheet loading lever