User`s manual

Roll material must be placed at a

predetermined shaft position.

Failure to do so may

result in dropping the

roll, leading to injury.

Acceptable material widths

90 mm to 1371 mm (3.5 in. to 54 in.)

*NOTE: when loading material with a width

of 90 mm to 430 mm (3.5 in. to 17 in.), set the

[EDGE SENSE] menu item to [DISABLE].

Pass the stoppers onto both ends of the shaft.

(The shafts (2 pieces), stoppers (2 pieces), and screws

(2 pieces) are included with the stand.)

* When passing the shaft through the stopper,

be sure to loosen the screws on the stopper

first.

Loading Roll Material

Align the media flange with the roll sheet edges, matching the roll sheet center ID.

(The media flange is included with the stand.)

1 Loading the Material

Stopper

Tighten loosely with the screws.

Shaft

Media flange

50.8 mm

(2 in.)

76.2 mm

(3 in.)

Setup for Printing