User`s manual

22
Five Modes
Main power switch (Rear of CJ-500)
Turn on when you first use the system, and after
that point it is generally left on.
Please do not turn it off unless transporting the
main unit, or if the system is not to be used for
long periods of time.
Sub power switch
POWER key
(control panel)
NOT
READY
READY
BUSY
SLEEP
PAUSE
This mode is in effect
immediately after the
POWER key is pressed to
switch on the CJ-500.
This is the state where
material has been loaded
and its size detected.
The CJ-500 can accept
data from the computer
when in this mode.
The CJ-500 is receiving
data from the computer
and performing printing
or cutting
The SLEEP mode is enabled when
the CJ-500 has been inactive for
a specified time. (When in the
SLEEP mode, the POWER LED
flashes once per 2 seconds.)
Any action of following cancels
SLEEP mode.
- Touch any key on the control panel.
- Send data from the computer.
- Open the front cover.
- Operate the sheet loading lever.
Pressing the PAUSE key causes operation to
stop temporarily.
Press the PAUSE key again to resume
operation.
Pressing the SETUP key while paused causes
remaining data to be cleared and returns to
the NOT READY mode.
If the material is removed while paused, the
CJ-500 goes into the NOT READY mode.
Use this switch to turn power on and off in
daily operation.
When power is turned on the system will enter
the NOT READY state (power on but sheet
not set).
When the power is turned on for the first time,
or turned on after removing the ink, the system
will execute ink fill.
This operation takes several minutes.
The CJ-500 has the following five modes (operating states).
Five Modes