Specifications

11
Part 2: Getting Started
Step 2: Scaling and Printing
PROCEDURE
1
Click the [Size] tab on the left upper corner of
the main screen.
2
Enlarging or reducing an image is available if
needed. Check the box as shown in the figure
and then enter a new value in the [Scale Per-
cent] window in percentage terms. You can also
enter a new value in the [Width] and the [Height]
window directly.
Then press [Enter] on the keyboard.
3
Make sure that the [Queue Processing Active]
box in the upper left of the main screen is
checked.
4
Select [Print] from the Main Screen and then
the [Basic] tab. Leave the other options on this
page unchecked at this time.
5
On the [Basic] tab, click the [RIP and Print].
The [Basic] tab will changeover to the [RIP Queue] tab.
6
Click [OK].
Make sure to click [OK], or processing doesn't start. If
you exit using [Cancel], the printing will not be per-
formed.
7
A [PostScript Interpreter] bar will launch on your
task bar during RIP'ing, followed by a [Print
Spooler] bar. Clicking on either of these bars
will launch windows that provide information
regarding the progress of your job.
2-1 Basic Operation for Printing
The unit of the Size
Inches or centimeters can be selected as the unit of the print size. From the [Options] menu, click [Inches] or [Centimeters].