User`s manual

33
Chapter 1 - Getting Started
1-6 Installing the Blade
6
Support the tool-securing screw from below and
install the blade holder.
7
Tighten the screw.
Tug the blade holder upward to make sure it does not
come loose.
8
Close the front cover, and press the [ENTER]
key.
Removing a Blade
1
Press the [MENU] key, and press the [ ] key
to make the following screen appear on the dis-
play.
2
Press the [ENTER] key to make the following
screen appear on the display.
When the screen shown in the figure appears, the print-
ing carriage similtaneously moves to the left.
3
Open the front cover, loosen the screw in the
figure, and remove the blade holder from the
cutting carriage.
4
Remove the blade.
5
Close the front cover, and press the [ENTER]
key.
Insert the blade holder
until the collar is flush
with the carriage.
When cutting is performed after printing, the cap tip of
the blade holder may scratch the printed surface. If this
is the case, lengthen the cutter blade extension.
Screw
MENU
REPLACE KNIFE
FINISHED ?
Screw
Press the push-pin
Blade
Blade holder