User`s manual

ManualsBrandsRoland ManualsComputer equipmentCAMM-2 PNC-2300

Part 2

Instruction Format Parameter Range [Default]

CC Character Code Angle CC Øc; Center angle

* 3 [5°]

CC;

ES ES Extra Space ES w (, h); w Character spacing *1 [0]

ES; h Line spacing *1 [0]

WD Write to Display WD c1c2 ... cn; cn Character CHR$ (32) — CHR$ (127),

WD; CHR$ (160) — CHR$ (223)

Instruction Format Parameter Range [Default]

!DW Dwell !DW t [terminator] t Dwell time 0—32767 [0]

!IO Input Home Position !IO x, y [terminator] x, y Coordinates of home position * 1

(designate by machine coordinate)

!MC Motor Control !MC n [terminator] n Motor ON/OFF switching -32768—32767 [motor ON]

!MC [terminator]

!NR Not Ready !NR [terminator] None

!OZ Output Z-coordinate !OZ [terminator] None

!PZ Set Z1&Z2 !PZ z1 (, z2) [terminator] z1 Z1 coordinates -3000—0 [0]

z2 Z2 coordinates 0—3000 [0]

!VZ Velocity select Z-axis !VZ s [terminator] s Feed rate (Z axis) 0—30 [mm/sec] [2 [mm/sec]]

!ZM XYZ Axis !ZM z [terminator] z Z coordinate -3000—0

Simultaneous Feed

!ZO Set Z0 !ZO z [terminator] z Z machine coordinate -3000—0

!ZZ Z !ZZ x1, y1, z1, ...... , xn, yn, zn [terminator] xn, yn XY coordinate * 1

zn Z coordinate * 1

Instruction Format Parameter Range [Default]

SM Symbol Mode SM s ; s Character or symbol 21h—3Ah, 3Ch—7Eh

SM ; [Clears symbol mode]

SR Relative Character Size SR w, h ; w Character width -128—+128 [%] [0.75 [%]]

SR ; h Character height -128—+128 [%] [1.5 [%]]

SS Select Standard SS ;

TL Tick Length TL lp (, ln) ; lp Tick length in positive direction -128—+128 [%] [0.5 [%]]

TL ; ln Tick length in negative direction -128—+128 [%] [0.5 [%]]

UC User Defined Character UC (c,) ∆x1, ∆

1 (,(c,) ∆x2, ∆

2...∆xn, ∆

n) c Tool control value -128—-99, +99—+128

UC ; ∆xn,∆yn Units of movement -99<∆xn, ∆yn<99

VS Velocity Select VS s ; s Feed rate for X and Y axis 0—60 [mm/sec] [2 [mm/sec]]

VS ;

WG Shade Wedge WG r, Ø1, Øc (, Ød) ; r Radius * 1

Ø1 Start angle * 3

Øc Center angle * 3

Ød Chord tolerance * 3 [5°]

XT X-Tick XT ; None

YT Y-Tick YT ; None

mode 1, mode 2 common instructions

Exclusive Commands for the PNC-2300