User`s manual

33
Part 2
Other Messages
Besides error messages related to commands or communication parameters, the following messages may also appear on the display.
Message Meaning
This message appears if repeat cutting is attempted when the cutting data exceeds 1 MB. The data
cannot all fit in the PNC-2300's data buffer, so repeat cutting cannot be performed.
This message appears if cutting is attempted while the cover is open.
This message appears if repeat cutting is attempted when the data buffer is empty. Send cutting data
before performing repeat cutting.
The PNC-2300 stops automatically if an excessive load is placed on the spindle during cutting. The
message shown at right appears at this time. The overload may be due to excessive hardness of the
material, an excessive amount of cutting, or a feed rate that is too fast. Investigate the problem and
eliminate the cause of the overload.
The error can be cancelled by switching the power to the unit off and then on again.
If the cover is opened during cutting, an emergency stop is performed and this message appears. All
cutting data stored in the PNC-2300 is deleted, and cutting cannot be continued.
If this message appears, stop sending data from the computer. Switch the power off and back on
again to cancel the error.
A message may be displayed indicating that buildup of cuttings has obstructed table movement.
Clean away all cuttings from around the table.
Switch the power off and back on again to cancel the error.