User`s manual

30
Part 2
Troubleshooting
Is the cover open?
Is operation paused?
Do the PNC-2300's connection parameter
settings match the settings for the com-
puter?
Is the power for the PNC-2300 switched on?
Has the connection cable come loose?
Is the correct connection cable being used?
Is the correct output device set for the
application or driver software?
The PNC-2300 will not operate when the cover is open. Close the
cover and try again.
If the [ENTER/PAUSE] key is pressed while the machine is in
operation, the message “Pause On” appears on the display and
operation is paused.
Choose “CONTINUE” and press the [ENTER/PAUSE] key again
to cancel the paused state.
Refer to “Setting the Connection Parameters” on page 6 to make
the correct settings.
Make sure the PNC-2300 is powered up.
Make sure the connection cable is plugged in securely with no
looseness at either end.
The type of connection cable varies according to the computer
being used. Also, some application software requires the use of a
special cable. Make sure the correct cable is being used.
Refer to the manual for the application or driver software to set the
output device correctly.
When the PNC-2300 does not work...
Is “REVOLUTION” set to “OFF?”
If “REVOLUTION” is set to “OFF,” the spindle will cut without
rotating.
Refer to page 26 and change the setting for “REVOLUTION” to
“ON.”
When the spindle does not rotate ...
The power does not come on...
Is the EMERGENCY STOP switch set to
STOP ( )?
Has the power cord come loose?
If the EMERGENCY STOP switch has been depressed, the power
will not come on when the power switch is turned on.
Refer to page 3 to set the EMERGENCY STOP switch to RE-
LEASE ( ).
Make sure the power cord is plugged in securely with no looseness
at either end.
Cutting depth varies in places (deep and shallow cuts)
Is the workpiece flexing?
Is the workpiece height uneven because of
the double-sided tape used for securing it
was stuck on poorly?
Check the setting and clamping of the workpiece.
Check how well the material is secured and reload it.
* Cutting to the same depth, even of workpieces of different thicknesses can be done if the depth regulator nose is used.
If you want to completely stop the operation of the PNC-2300, turn off the power switch.