User`s manual

28
Part 2
Reattach the brush covers.
5
Reattach the spindle cover.
6
Included with the PNC-2300 are two motor brushes (one set) which can be used the first time the motor brushes are replaced. Contact
Roland DG Corp. when replacing for the second time or after.
The above three cleaning operations are the only maintenance procedures that the customer needs to perform.
Oil supply and other maintenance are not required.
Operate the spindle motor alone, with no cutter installed or material loaded.
Checking the Spindle Motor
Turn the power ON.
1
Display the screen shown below and make sure that
REVOLUTION” is set to “ON.”
2
Close the cover.
3
Press the [SPINDLE ON/OFF] key to rotate the
spindle.
4
Attach the brush
cover on the
opposite side as well
Head
Spindle cover