User`s manual

23
Part 2
Canceling the Paused State to Resume Cutting
After changing the feed rate, cancel the paused state. Cutting then resumes at the new feed rate or spindle speed.
Press the [MENU] key to make the following screen
appear on the display.
1
Press the [ ] key to move the blinking cursor (“ ”) to
“CONTINUE,” and then press the [ENTER] key.
2
In the case that you begin cutting and then find that you have sent the wrong cutting data, perform the following operation.
Stopping the Cutting Process
Press the [ENTER/PAUSE] key while cutting is in
progress. One cutting step is performed, after which
operation stops. The display changes to show the
following message.
1
Use the software to stop data output.
2
Download Data
PNC-2300
RS-232C
Baud rate : 9600
Data bit : 8
Stop bit : 1
Parity : None
Handshake : Xon/Xoff
Device Name Protocol
Interface
OK
CANCEL
Download data now. Click “CANCEL”, then stop to download.
Press the [ ] key to move the blinking cursor (“ ”) to
“STOP,” and then press the [ENTER] key.
3