User`s manual

17
Part 1
Output Instruction Command setting Coordinate unit setting
model system on the PNC-2300 on the PNC-2300
PNC-2300 CAMM-GL I AUTO 0.01 mm
CAMM-2 Series CAMM-GL II AUTO 0.01 mm
CAMM-3 Series CAMM-GL I AUTO 0.01 mm
11. Sending Cutting Data
The PNC-2300 performs cutting after receiving cutting data from the computer (application software).
Data may be output, for example, after it has been created using any of a number of applications, or from driver software.
In this section, general matters related to data output are explained. Refer to this section when carrying out data output. For details of
the cutting data output method, refer to the operation manual for the application software or driver software used.
Setting the Output device
Please select from among the models shown below when making the settings for output device with the application software.
* When set to “AUTO,” the machine automatically determines whether the mode 1 or mode 2 instruction system is used.
Sample Settings for Application Software
Output device selection
Device name
[PNC-2300]
Protocol
△
PNC-2300
PNC-2200A
PNC-2100A
PNC-2200
▽
Baud rate
Data bit
Stop bit
Parity
Handshake
9600
4800
2400
OK
CANCEL
Centronics
RS-232C
Interface
[RS-232C]
Select either the parallel
(Centronics) or the serial (RS-
232C) interface. Choose the one
that the host computer and the
PNC-2300 are connected by.
Select PNC-2300. If it is not
listed, select CAMM-2 series or
CAMM-3 series.
Cautions During Cutting
Opening the cover during cutting results in an emergency stop. Any cutting data in use becomes invalid, and cutting cannot be contin-
ued.
If the cover must be opened during cutting, first press the [ENTER/PAUSE] key to pause the unit. Confirm that operation has stopped,
and then open the cover. After the cover has been closed, cutting resumes when the paused state is canceled.
The spindle will not rotate while the cover is open.