User`s manual

11
Part 1
Setting the Z0 Position
"Z0" is the origin point for the Z axis. This is normally set at a position which corresponds to the surface of the secured workpiece when
mounting the cutter.
Press the [MENU] key to make the following screen
appear on the display.
1
Press the [ENTER] key to make the following screen
appear on the display.
2
Press the [ ] key to move the blinking cursor (“ ”) to
“Z-Axis,” then press the [ENTER] key.
3
Make sure the blinking cursor is on "Z0" and press
the [ENTER] key.
4
Make sure that “< >” appers.
(1)
(2)
(1) (2)
(3)
Vacuum up cutting chips and grit during an on going cutting operation, using the
vacuum adapter, and commercial vacuum cleaner.
Commercial vacuum cleaner
Vacuum duct
32 mm (1-5/16")
30 cm (11-13/16") or more
Vacuum
adapter
1
Pass the vacuum
hose through the rear
panel of the unit.
2
Attach the vacuum
adapter.
3
Secure the vacuum
hose in place.
When the fitting diameters do not match or when the vacuum duct cannot be inserted into the suction opening of the
vacuum cleaner, use strong commercial tape (cloth or electrical) to join the fittings.
7. Vacuum Cleaner Connection
Always allow a minimum gap of 30 cm (11-13/16") on the side where the vacuum hose
exits. The vacuum hose must have sufficient space in which to move. When the vacuum
hose cannot move smoothly, it can cause malfunctions or errors in operation.