User`s manual

Part 1

6. Loading a Cutter

Replacing the Cutter holder and Collet

Loading Workpiece Using Double-sided Tape

Apply the double-sided tape to the bottom of the workpiece and secure it to the table.

Double-sided tape

Workpiece

Install a cutter holder and collet which are suitable for the cutter

to be used. The combination of cutter, cutter holder, and collet

is correct if the thickness of the cutter just fits in the hole in the

cutter holder and collet.

Two types of cutter holders and collets are included with the

engraving machine. The cutter holder and collet which are

originally installed are for cutters with a diameter of 3.175 mm

(1/8"). These are used for installing installed the included

character cutter (diameter 3.175 mm (1/8")). (The cutter holder

and collet packed with the machine are for cutters with a

diameter of 4.36 mm (11/64").)

Remove the depth regulator nose.

Bottom of the head

Remove the cutter holder and collet. To remove the

collet, use the wrench included with the engraving

machine.

Install the cutter holder and collet for the cutter to be

used.

Micrometer

dial assembly

Head

Wrench

Collet

Head

Cutter holder

Wrench

Collet

Cutter holder

Loosen the

screw by hand

Knurled

retainer nut

Depth nose