User`s manual

Part 1

5. Loading a Workpiece for Cutting

To load workpiece, use the adhesive sheet or clamps included with the machine.

When performing engraving that subjects the workpiece to a load, use the clamps to secure the workpiece in place. When engraving the

edge of the workpiece or when loading a workpiece with a thickness of 10 mm (25/64") or more, use the adhesive sheet.

Large-size material (i.e., material that is about the same size as the PNC-2300's table) cannot be affixed to the table securely using the

adhesive sheet or clamps. In such cases, use commercially available double-sided tape to secure the workpiece in place.

* A vacuum table (ZV-23A) and a center vise (ZV-23C) are optionally available and should be purchased if needed.

Loading Workpiece Using the Adhesive Sheet

Place the adhesive sheet on the table and press it

down.

Place the workpiece to be cut on the adhesive sheet

and fasten it while pressing down.

Do not attempt to wash the adhesive sheet with water. Doing so will damage the adhesive surface and make it impossible to grip

the material.

Adhesive

sheet

Adhesive

sheet

Workpiece

Store the adhesive sheet in a location free from dust.

Loading Workpiece Using the Clamps

Place the workpiece on the table.

Slide the square portion protruding from the bottom

of the clamp plate into the groove on the table to

secure the workpiece in place.

Workpiece

Tighten

Groove

Workpiece