User`s manual

6
Part 1
4. Setting the Connection Parameters
Connection with a parallel cable is called a “parallel connection,” and connection with a serial cable is called a “serial connection.”
Make the appropriate settings on both the computer and the PNC-2300 to configure the equipment for the type of connection that has
been made. Normally, the setting on the PNC-2300 should be made to match the setting on the computer. The steps below describe how
to set connection parameters on the PNC-2300. To make the settings on the computer, refer to the manual for the computer or the
software in use.
Press the [MENU] key to make the following screen
appear on the display.
1
Press the [ ] key to move the blinking cursor (“ ”) to
“I/O,” and then press the [ENTER] key.
2
Press the [ ] key to move the blinking cursor (“ ”) to
“AUTO,” and then press the [ENTER] key.
3
Press the [MENU] key once.
Make the settings for stop bit, then press the
[ENTER] key.
4
Press the [MENU] key once.
Make the settings for parity check, then press the
[ENTER] key.
6
Press the [MENU] key once.
Press the Make the settings for data bits, then press
the [ENTER] key.
5
For serial connection only
Press the [MENU] key once.
Make the settings for handshake, then press the
[ENTER] key.
8
Press the [MENU] key once.
Make the settings for baud rate, then press the
[ENTER] key.
7
*“REPEAT” is displayed only
when the buffer size has been
expanded.
For serial connection only
For serial connection only
For serial connection onlyFor serial connection only