User`s manual

2
Part 1
Depth regulator nose
This is adjusted when engraving a material which
does not have uniform thickness.
Cover
Opening the cover during cutting results in an emergency stop.
Any cutting data in use becomes invalid, and cutting cannot be
continued.
If the cover must be opened during cutting, first press the [EN-
TER/PAUSE] key to pause the PNC-2300, then open the cover.
After the cover has been closed, cutting resumes when the paused
state is canceled.
The spindle will not rotate while the cover is open.
2. Part Names and Functions
Parallel connector
A parallel (printer)
cable is connected here.
Serial connector
A serial (RS-232C)
cable is connected here.
Left side view
Right side view
Power switch
Power connector
The power cord included with
the machine is connected here.
Head
This moves the spindle (cutter) up and down). The
head performs X-axis, Y-axis and Z-axis movement.
External output
connector
Described on the
following page
Table
The table grips the workpiece to be cut.
Scale (for Checking the Z-axis Cutting Range)
This can be used to confirm the cutting range of the
Z axis.
The cutting range of the Z axis is 30 mm (1-1/8").
According to the scale, the cutting range is 5 to 35
(mm) when the depth-regulator nose is installed, and
0 to 30 (mm) when not installed.
Z adjust screw
Loosen the Z adjust screw if it is
necessary to adjust the depth regulator
nose for performing engraving.
Cutter holder
This is where the cutter
is mounted.
Scale (for Checking the Z1 Position)
When using the depth-regulator nose,
this can be used to confirm the Z1
position that has been set.