Owner`s manual

MaxMotion for Machines Chapter 6-97
columns in separate files. Edit individual files and use merged files
mainly for viewing and sending it to the machine. Merge job command
will allow you to insert a previously saved job file (*.max or *.tpl files)
into your current design that is already on the screen. The merging will
take place in the following manner:
The top left points of the two saved files are matched while merging. If
the plate sizes of the two files are not the same, a larger of the two plate
sizes is created to hold and merge both the jobs. The condense mode of
the merged jobs is automatically set to single line, thus eliminating
chances of similar lines affecting each others. The width percent of
each line is set equal to its condense percent to prevent it to condense
differently in plates of different sizes. Lines having Fit justification are
changed to center justification to prevent the lines from stretching to
margin of a different plate size. The commands like Magnify or Save-
Open will not alter the layout.
Example of Column 1, 2, 3 and 4 are provided with the Maxmotion
software. Open Column 1 first and then merge column 2, 3 and 4
one after another to create this plaque as shown in the picture. looking
at each file of the different colums will give you an understanding of
how to create these files.