Owner`s manual

MaxMotion for Machines Chapter 3-71
the blue dots are located.
Step 5. Click on the Setting menu and Select ‘Fill’ with 0.060 in.
Observe that the cursor changed to a paint-brush.
Step 6. Drag the paint brush inside the logo and click anywhere.
Step 7. MaxMotion is smart enough to fill only the appropriate area.
Step 8. Click on the Edit menu and Select ‘Select All’. Go to the
Settings menu and select Fill with another size and click
inside the logo.
Step 9. Note the warning for redoing the fill, click OK to fill again.
Step10. Click on the Edit menu and Select ‘Select All’. Then Select
Paint-brush tool, if it is not already selected. Hold down the
shift key and watch the Paint-Brush tool turn empty
instead of filled.
Step11. Continue to hold down the shift key and click the empty
paint-brush inside the logo. The fill will be removed.
Step12. Now let us do Negative Engraving. Instead of filling the
logo, we want to fill all the other area on the plate. So far the
design plate is a reference plate and the plate rectangle is not
sent to the engraving table.
Step13. Click on the Graphics menu and Select ‘Cut Design
Window’. Observe that the shadow around the plate is gone.
Now the design window rectangle will be sent to the table.
Step14. Click on the Edit menu and Select ‘Select All’. We need to
change the path directions of all shapes to fill the back
ground area.
Step15. Click on the Edit menu and Select ‘Reverse Path’. Observe
the change in the position of the blue dots.