Owner`s manual

52 MaxMotion for Machines
( 6) Create a multi line badge in Auto Layout
(Virtual Controller and HPGL)
Step 1. Click on the Material menu and Select the Engraving
Material you wish to use.
You can edit materials to set up proper speeds, depth, lift,
and dwell, if necessary.
Step 2. Click on the Job Design menu and Select ‘Auto Layout’.
Select the plate size. Enter 3 for the number of lines. Auto job
layout has default selection of inches for the line height. You
can choose percentage instead if you are used to selecting
relative heights for each line. If you want all lines to be same
height, click “Set All Sizes”. Select line alignment, margins
and line space distribution. Engravable area needs to be
selected only if you are selecting line heights in percentage.
Set margins to 0.15in. for both left and right. Set Top and
Bottom margins to 0.15in. Click ‘create’ and you will see
boxes in the plate representing lines.
Step 3. Select text cursor and click inside the top box on the screen
unless the text cursor is already blinking in the first box. Start